Expert ac repair in Nassau Bay, TX. NATE-certified technicians, quality equipment, and results you can count on.
KIC Refrigeration delivers expert air conditioning repair in Nassau Bay, TX, diagnosing compressor failures, refrigerant leaks, frozen evaporator coils, and electrical faults using superheat, subcooling, and amp draw measurements. Our EPA Section 608 certified technicians restore rated SEER output through manufacturer-guided repair procedures across all major AC brands.
With a population of 5,181, Nassau Bay is home to thousands of properties that depend on reliable heating and cooling. Our ac repair team in Nassau Bay, TX combines local climate knowledge with NATE-certified expertise to deliver results that restore comfort and improve efficiency. Every project begins with a thorough system evaluation so we can recommend the right solution for your specific situation.
When you choose KIC Refrigeration for ac repair in Nassau Bay, you get a team that shows up on time, diagnoses accurately, and treats your property with respect. We handle all the details — from equipment selection and permits to final commissioning and warranty registration — so you can focus on staying comfortable.
Our proven process ensures your ac repair project is done right the first time.
KIC Refrigeration begins every AC repair in Nassau Bay, TX with a systematic assessment. We verify 24-volt control voltage at the thermostat, check high and low voltage wiring for damage, inspect the disconnect for burned contacts, confirm the breaker is properly sized, and visually inspect both indoor and outdoor units before powering up the system for testing.
At your Nassau Bay property, our technician tests the run and start capacitors with a capacitance meter, checks the contactor for pitting and voltage drop, measures compressor amperage against rated load amps, and reads suction and discharge pressures to calculate superheat and subcooling against the manufacturer charge chart for current conditions.
We replace the failed component — capacitor, contactor, fan motor, compressor, or metering device — using parts rated for your system. For refrigerant leaks, we locate the leak, repair or replace the leaking component, evacuate, and recharge the system by weight.
KIC Refrigeration verifies every AC repair in Nassau Bay, TX with a comprehensive performance test. We confirm temperature split, superheat, subcooling, compressor amperage, condenser fan amperage, blower CFM, and thermostat operation. We document all readings and explain the results before we consider the job complete.
Everything you need to know before scheduling ac repair for your property.
AC repair in Nassau Bay typically costs $150 to $500 for common component failures including run capacitors ($150 to $250), contactors ($150 to $350), condenser fan motors ($250 to $500), and blower motors ($300 to $600). Compressor replacement is the most expensive repair at $1,500 to $3,500 depending on unit tonnage and whether the system uses R-410A or older R-22 refrigerant. Evaporator coil replacement runs $800 to $2,500 including the refrigerant recovery and recharge. KIC Refrigeration provides a detailed written estimate with itemized parts and labor costs before beginning any AC repair at your Nassau Bay property so there are no surprises on the invoice.
An AC that runs but produces little or no cooling is most commonly caused by low refrigerant charge from a leak, which reduces the suction pressure and causes the evaporator coil temperature to drop below 32 degrees, forming ice that blocks airflow completely. Other causes include a dirty condenser coil that cannot reject heat, a failed compressor that runs but does not pump refrigerant, a stuck or failed metering device — either a TXV or fixed orifice — that restricts refrigerant flow, or a blower motor running at reduced speed due to a failing capacitor. KIC Refrigeration connects manifold gauges at your Nassau Bay home and measures suction pressure, discharge pressure, superheat, and subcooling to diagnose the exact cause.
Most AC repairs in Nassau Bay are completed in 1 to 2 hours during a single service visit. Capacitor and contactor replacements are quick fixes that take 15 to 30 minutes of hands-on time. Fan motor and blower motor replacements take 1 to 2 hours including wiring and testing. Compressor replacement is the most time-intensive repair at 3 to 6 hours because it requires refrigerant recovery with an EPA-certified machine, compressor removal, new compressor installation, nitrogen-purged brazing, pressure testing at 300 PSI, evacuation to below 500 microns, and recharging by weight. KIC Refrigeration arrives at your Nassau Bay home with a fully stocked truck to complete most repairs in a single visit.
KIC Refrigeration repairs every major air conditioning brand installed in Nassau Bay homes and commercial properties — Carrier, Trane, Lennox, Rheem, Goodman, Daikin, York, Bryant, Amana, Ruud, Heil, and all other manufacturers. Our technicians hold EPA Section 608 Universal certification for refrigerant handling and are trained to work with R-410A, R-22, R-32, R-454B, and all other regulated refrigerants found in residential and light commercial systems. Whether your AC is a 2-ton window package unit or a 5-ton split system, a 20-year-old R-22 unit or a brand-new inverter model, KIC Refrigeration has the diagnostic capability and parts access to repair it correctly at your Nassau Bay property.
Real feedback from customers across the country about the quality of our work.
"Heat pump tune-up went fine. Technician was a bit late but called ahead to let me know. The actual service was thorough and professional."
"Heat pump was not heating properly. They found a bad reversing valve and had it swapped out the next day. House is warm again and the system runs great."
"Our dryer was taking forever to dry clothes. Turned out the vent was almost completely clogged. Quick cleaning and now it works like new again."